Geothermal heating and cooling - Installation Manual
Geothermal heating and cooling systems are those that incorporate geothermal energy to produce heat. Geothermal energy is energy that originates within the Earth's surface and is surrounded by radioactive decay of minerals and also of solar energy that is absorbed on the surface of the Earth formed.
Heating and cooling using geothermal energy to operate off the ground. Earth's surface is always in motion and crustal shortening. Therefore, the energyis continuously released in the form of hot water, steam or heat. These resources can be used in homes to be comfortable and energy efficient.
With the growing environmental awareness, the geothermal energy with great strides in the household. It 'true that require a greater investment than other types of devices, but in the long run the benefits are many and greatly reduced by paying the heating bill.
Here are some basic guidelinesof a heating or cooling, which is run on geothermal energy.
1 Assess the energy needs. This will help you decide the type of equipment should help to install in your family. There are several types of geothermal equipment available on the market, such as horizontal loops, vertical loops, and well water. To play a number of factors play an important role in choosing the right device or your home, such as soil type, location, surfaceSpace, the availability of a pond or other water source. I ask the help of a professional engineer can be very helpful in this regard.
2 Fossati power or furrows, that may be required to install the system. If you install a water fountain or a thought in the geothermal unit, you can not dig require each cycle. Trenches alone, you have to do would be his for the laying of cables between your site and your home.
3 After the necessary holes, lay theTubes. Pipes and tubes have different specifications. They also have several installation options. You must follow the instructions that were provided by the manufacturer.
4 Install the pump in a geothermal power plant is required. it must be in compliance with housing and electrical codes in your community.
5 Connect the rings of the circulation pump and heat pump.
6 Start the pump valve and open the air separator. Fill the tube with a mixtureWater and antifreeze, if you are a closed system.
7 If you have a cooling system, you must set your thermostat at a temperature of at least 10 degrees below room temperature.
If all steps are performed correctly, the installation was completed successfully.
No comments:
Post a Comment